4 Tips On How To Get A Backpack Zipper Unstuck

Tweezers and Safety Pins

A common cause of this annoying issue can sometimes be the surrounding fabric getting caught in the teeth of the zipper. Look closely at the area that’s stuck and check for any obstruction or snag that might be impeding the teeth. Also look to see if the lining or material is folded, tangled or caught

How can you tell if it’s a snag?

  • If the zipper refuses to move chances are a material may be the cause. Snags are usually to blame when a zipper completely refuses to budge.

Fix the snag

Now that you have found the material impeding the movement of the zipper, grab the fabric in the direct vicinity if the obstruction and gently pull it in the opposite direction of the way the zipper runs.

If you have trouble grabbing the material to get a good tug, try a pair of tweezers to get a better grip of the fabric.

  • If you’re still having issues, try to push the fabric stuck inside the teeth with a needle like object similar to a safety pin. Just make sure you don’t do it to hard or you may damage the material.

Try moving the zipper back and forth.

Maintain a hold on the fabric and softly pull the zipper up and down. If you gently move the zipper back and forth, you my be able to release the fabric. These small movements can sometimes ease the tension and clear the stuck zipper.

Video

Avoiding Fabric Caught in Zipper

The common-sense way is to not absent-mindedly pull your zipper closed. This attitude is not good as that leaves lots of room for the loose fabric to get to the zipper. Wearing very loose clothing also has a tendency to get stuck.

Try to control the loose fabric so that it does not get close to the zipper tracks. Next, do not be in a rush. When a person is in a hurry they tend to zip up their clothes in a haphazard manner throwing caution to the wind.

That situation is probably the most common fabric caught in the zipper problem. You are not paying attention to what you are doing or where your clothes are at and before you know it, your fabric is stopping the zipper from closing.

Always take your time around zippers and stay focused on what you are doing. A caught zipper takes more time to unclog making you even later than you thought you would be.

Those are the common sense ways to avoid getting your fabric caught in your zipper. Keeping the zipper track lubricated is another way. This can be done in your spare time and it doesn’t take that long to lubricate a zipper track.

Other Scenarios

If the zipper is clean, there’s no trapped fabric (remember this could also be on the interior), then your zipper may be faulty. Some people recommend greasing zippers, and you could try it if you happen to have any kind of lubricant to hand.

If your backpack zipper is well and truly broken you should consider your options and upcoming needs before breaking it further.

If you’re going to be relying on your backpack for the next few days, you should consider cutting through from another internal compartment with a functioning external zipper if possible. This will maintain the integrity and functionality of your backpack, enabling you to continue your hike with the least inconvenience.

If this isn’t possible, decide if you want to rip or cut open your backpack at the zipper opening. Try to replace it later upon returning home. If there’s another more convenient place to cut into your backpack. This opening should be created in a position where it would be easier to tie or somehow fasten shut for the rest of your hiking expedition.

How to Fix a Zipper With Fabric in It

Everyone may have their own idea about how to unstick a zipper that has fabric caught in it. A straight pin is one of those around the house solutions and here are some solutions that use around the house items:

Fingers or tweezers – both are good tools to use when the fabric is not really jammed in tight.

Use a cotton swab to apply one of the following – paraffin, a bar of soap or candle wax. Make the application above and below the stuck section as well as on the zipper tab. This is an easy lubricant to use to get the zipper to slide easier.

Use a pencil tip – rub the graphite lightly onto the zipper teeth. Be careful that you do not apply too much or your zipper may jam on the graphite.

Soak the zipper area – you can use either saltwater and vinegar for 3 hours or sacrifice a bottle of coke for an hour. These solutions need a little time to remove what is jamming your zipper.

One simple tip to help prevent the jamming of your zipper. Use a little paraffin, candle wax or a bar of soap from time to time to keep the zipper track lubricated and easier to use. These items also protect against rust.

Find a Lubricant

Grab a lubricant from around the house. A lubricant can be anything that will help reduce the friction of the zipper. Lubricants can help remove dust and dirt from the zipper teeth. This can be helpful on older items with zippers.

Common household lubricants:

  • bar of soap
  • chapstick
  • Windex
  • wax candles
  • petroleum jelly
  • crayons
  • lip balm
  • any slick substance

Any of the above lubricants will work. Once you find a lubricant, apply a generous amount of lubricant on to the zipper of teeth that are still connected.

As your adding more lubricant try moving the zipper back and forth. Moving the zipper back and forth will help the lubricant get deeper into the teeth. Just try not to get the material of the bag dull of the lubricant.

If you decide to use an oily substance like petroleum jelly, try using a cotton swab to avoid spills or smearing.

If you decide to use Windex apply and try moving the zipper after a couple of minutes.

Once the lubricant is applied, try moving the zipper gently to see if it will release. If the lubricant worked properly, the zipper should be back to normal. If the zipper is still stuck, repeat the process until the zipper is free.

Snagged Zippers

If the zipper is snagged on the surrounding fabric, gently try to reverse it. The more gently you can do this the less likely you are to cause any lasting damage.

Sometimes a good deal of patience will be required, holding the trapped fabric a millimeter to the left or right can help to release the slider while slowly reversing it.

Ways to Unstick a Stuck Backpack Zipper

If your backpack zipper is refusing to budge, as tempting as it may be to start pulling hard to release it, it’s important to stop and assess the situation.

Is any of the surrounding fabric trapped? Was the zipper working fine up until now? Are you going to be relying on your backpack for the next few days?

Before possibly irrevocably breaking your backpack, taking the time to examine the problem can help to provide a solution.

Snagged Zippers

If the zipper is snagged on the surrounding fabric, gently try to reverse it. The more gently you can do this the less likely you are to cause any lasting damage.

Sometimes a good deal of patience will be required, holding the trapped fabric a millimeter to the left or right can help to release the slider while slowly reversing it.

Trapped Dirt

If you can’t see any obvious reason for your backpack zipper to be stuck, it could be caused by a buildup of trapped dirt within the slider. Try blowing hard to get any loose particles out before they cause any further problems.

Gently try to manipulate the zipper, stopping immediately if there’s any sign of it straining. You may want to try wetting or submerging the zipper area whilst gently jiggling it to remove any trapped dirt.

Other Scenarios

If the zipper is clean, there’s no trapped fabric (remember this could also be on the interior), then your zipper may be faulty. Some people recommend greasing zippers, and you could try it if you happen to have any kind of lubricant to hand.

However, this can often be a bad idea as it can attract dirt and grit causing them to stick inside the zipper, making the problem worse, or creating a new one. However, this is a great last-ditch option and could save your backpack.

If your backpack zipper is well and truly broken you should consider your options and upcoming needs before breaking it further.

If you’re going to be relying on your backpack for the next few days, you should consider cutting through from another internal compartment with a functioning external zipper if possible. This will maintain the integity and functionality of your backpack, enabling you to continue your hike with the least inconvenience.

If this isn’t possible, decide if you want to rip or cut open your backpack at the zipper opening and try to replace it later upon returning home, or if there’s another more convenient place to cut into your backpack.

This opening should be created in a position where it would be easier to tie or somehow fasten shut for the rest of your hiking expedition.

Do you provide any video tutorials for How To Get Zippers Unstuck?

Surely, we usually offer users the guidance in both posts and video tutorials for How To Get Zippers Unstuck. These videos are posted for the user’s reference with more details about the making way. Therefore, you can find by How To Get Zippers Unstuck searching on our tool to know more details.

How to Avoid Future Zipper Problems

Zipper problems often occur because of misuse, by taking good care of your zipper you will reduce the chances of it getting stuck and extend your backpack’s lifespan.

Helpful hints to keep your zipper from sticking:

  1. Don’t overfill your backpack. Not only is it going to be heavy, trying to squeeze in extra items will strain the zipper. Plan before packing.
  2. Always open the zipper fully when putting your stuff inside. You may just need to quickly slip a container in, but if the opening isn’t wide enough this will cause the teeth to tear apart and increase the likelihood of your zipper getting stuck in the future.
  3. Don’t ever force your zipper, you will cause it to become (even more) stuck. If you’re not the patient type and you don’t urgently need access to your backpack contents, give it a few minutes and try again later.
  4. Clean your zipper after every hike, especially in dirty conditions. Give your backpack a good shake out and wipe over in accordance with the manufacturer’s recommendations.
  5. Pay attention to the quality of zippers, their positioning and how well they function on future purchases. When possible try before you buy or ask questions online.

3. Clear It Up

It turns out Windex isn’t just great for cleaning glass surfaces in your home; it’s just as useful for fixing a stuck zipper. Spray the pull tab and its surrounding teeth with Windex—just one pump should be enough—and wait a moment for the liquid to work its magic on any residue that may be causing the zipper to stick. Then, gently move the zipper pull back and forth along the teeth, slowly allowing it to free itself. The slickness and cleansing agents in the Windex should work together, helping you jiggle the stuck zipper back into working order.

Advertisement

Tags

Leave a Reply

Your email address will not be published.